Car key fob programming – Ford Fusion 2.5 Duratec 2004

Car Forum Repair & Maintenance Car key fob programming – Ford Fusion 2.5 Duratec 2004

  • sogama
    Community Member
    January 15, 2024 at 3:36 pm

    Writing from the UK regarding 2004 Ford Mondeo Ghia X. Just purchased the car but only one key fob works remotely. If I programme the one which does not work remotely, it works but then the other remote, the one which worked initially, no longer works remotely! What do I need to do to get them both to work remotely?

    Brand: Ford
    Model: Fusion
    Year: 2004
    Engine: 2.5 Duratec

    alexcray
    Community Member
    February 28, 2024 at 2:39 am
    Up
    0
    Down

    Within the 20 seconds of “learn mode,” press any button on the first key fob. The system should learn the code for this fob, and the LED should flash once.

    alexcray
    Community Member
    March 4, 2024 at 2:20 am
    Up
    0
    Down

    The first step is to check your car’s owner’s manual. Sometimes, there might be a specific procedure outlined for programming multiple key fobs for your exact model. This method might involve a different button sequence or include additional steps to retain both fobs’ functionality.

    alexcray
    Community Member
    March 5, 2024 at 2:22 am
    Up
    0
    Down

    Your car’s manual might have specific instructions for programming additional key fobs. It might involve a specific sequence using the working key fob and the car’s ignition.

    alexcray
    Community Member
    March 6, 2024 at 2:34 am
    Up
    0
    Down

    The car needs to be put into “learn mode” for it to recognize and accept new key fob codes. This usually involves a specific sequence of actions with the ignition key or buttons within the vehicle (refer to your car’s manual for the exact steps).

    alexcray
    Community Member
    March 13, 2024 at 3:48 am
    Up
    0
    Down

    Consult your Mondeo’s manual for specific instructions, but it typically involves inserting the working key into the ignition, turning it to position II (one notch before starting) a specific number of times (often four). This puts the system in programming mode.

    alexcray
    Community Member
    March 28, 2024 at 3:31 am
    Up
    0
    Down

    Following your Mondeo’s manual, there might be a way to clear the car’s memory of programmed fobs. This could involve a specific button combination or sequence with the key in the ignition.